07-23-2019, 11:04 AM
useruser Wrote:...unfortunately the problem still exists with beta2.
with another project, including an animated windeffector, fumefx quits simulating after a couple of frames. i will post the projectfile a bit later.
what i recognize until now: the fumefx-simulation works without any trouble with higher spacing values. for exampke:
spacing value „2 cm“ works fine, but when i decrease the grid-resolution down to „0,5 cm“ fumefx shows the same behavoir as in beta1
please support, can you confirm that?
thanks in advance!
You always have to read how much memory your simulation is going to use, so 0.5 cm in relation to your FumeFX grid is probably way too much for your system. Going from spacing 2 to 0.5 means 64 times more memory (4^3).