+- Sitni Sati Forums (https://forum.afterworks.com)
+-- Forum: Products (https://forum.afterworks.com/forumdisplay.php?fid=4)
+--- Forum: FumeFX [max] (https://forum.afterworks.com/forumdisplay.php?fid=8)
+--- Thread: Smoke not emitting consistently (/showthread.php?tid=439)
Smoke not emitting consistently - Jordan - 10-17-2007
Hi guys,
Im trying to make snow being blown off the peak of a mountain.
I have a simple source just down one side of the mountain pointing up it with a directional velocity of 100 and a smoke amount of 200. I have a horizontal wind blowing across the mountain.
Some of my fume settings are as follows:
Quality 2
Max Iterations 100
Stride: .4
gravity .5
vorticity .05
Dissipation Strength: 0
Diffusion 0
The problem I have is that it starts off fine and looks good for a bit but then after about 250 frames the emitter hardly puts out any smoke, not enough to even get over the peak of the mountain.
I have tried increasing the source smoke amount but it doesnt really change anything.
Any ideas?
Re: Smoke not emitting consistently - Rif - 10-17-2007
post a preview plz..