04-24-2017, 05:06 PM
Kresimir,
Thanks for looking into this!
Re: Picking Events
Attached is a screegrab of the pick event dialog. I can't tell which event is 005 as the dialog is so small. Likewise, after picking the event, I can't tell which event has been picked as the particles dialog also is small and crops the full name.
(For a future update, it would be good to have the pick event dialog be larger or resizable. Also it would be good to have tooltips that show the particles name pop up when hovering over the particles dialog).
Re: Picking Event005
I renamed the PFSOURCE to a shorter name so I could see which event I was picking in the dialogs. I picked Event 005... it made no difference.
After picking Event005... when the Size-Sphere Radius AFC is set to go from small to large (1 to 10) and the AFC is enabled, the first (birth) frame of the particles shows a single particle/puff at radius 1. The next frame (and all later frames) show the particle/puff at radius 10. When the AFC is disabled, all the particles show as radius 1. The particle lifespan is 30 frames... it is jumping from 1 to 10 in one frame instead of 30 frames.
I must be doing something wrong. Do you have a modified version of the file I sent you that works?
Thanks again.
Thanks for looking into this!
Re: Picking Events
Attached is a screegrab of the pick event dialog. I can't tell which event is 005 as the dialog is so small. Likewise, after picking the event, I can't tell which event has been picked as the particles dialog also is small and crops the full name.
(For a future update, it would be good to have the pick event dialog be larger or resizable. Also it would be good to have tooltips that show the particles name pop up when hovering over the particles dialog).
Re: Picking Event005
I renamed the PFSOURCE to a shorter name so I could see which event I was picking in the dialogs. I picked Event 005... it made no difference.
After picking Event005... when the Size-Sphere Radius AFC is set to go from small to large (1 to 10) and the AFC is enabled, the first (birth) frame of the particles shows a single particle/puff at radius 1. The next frame (and all later frames) show the particle/puff at radius 10. When the AFC is disabled, all the particles show as radius 1. The particle lifespan is 30 frames... it is jumping from 1 to 10 in one frame instead of 30 frames.
I must be doing something wrong. Do you have a modified version of the file I sent you that works?
Thanks again.