05-23-2011, 04:52 AM
Hey All,
I simmed out some Fume, and then a wavelet simulation. During the simulation is errored saying that I was missing frame 117 (then it went on to waveletting the frames after). I went back in to investigate and, indeed, frame 117 was missing. Not sure how or why, but its gone.
If I move the post-117 FXD files and try and resimulate from that frame, I get a message saying there is data up to 133 (the end of the sequence) and would I like to start there. I presume this information is coming from the FDC file. Is there a way to restart the simulation at frame 117-133 without resimming from the very beginning?
Thanks much!
~tsp
Todd Sheridan Perry
CG Supervisor, Prime Focus
I simmed out some Fume, and then a wavelet simulation. During the simulation is errored saying that I was missing frame 117 (then it went on to waveletting the frames after). I went back in to investigate and, indeed, frame 117 was missing. Not sure how or why, but its gone.
If I move the post-117 FXD files and try and resimulate from that frame, I get a message saying there is data up to 133 (the end of the sequence) and would I like to start there. I presume this information is coming from the FDC file. Is there a way to restart the simulation at frame 117-133 without resimming from the very beginning?
Thanks much!
~tsp
Todd Sheridan Perry
CG Supervisor, Prime Focus