• 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Afterburn and Thinking Particles
#1
Hello, I am using Max 2014 and Afterburn 4.1.3 with thinking particles 5.0.0.48. when I add thinking particles to the particles dialog in Afterburn it doesn't list my particle groups but instead I get a Chinese character and after burn appears to be very unstable.

I have attached a screen capture to illustrate what I am talking about.

Has anyone else run into this problem at all? I tried loading the latest build of Afterburn again but the problem is still consistent.

Thanks.

-Christian
  Reply
#2
Hello,

Have you tried AfterBurn 4.1.4?
It seems to be working fine here.

Regards,

Kresimir Tkalcec
  Reply
#3
Thanks, I downloaded (newly) the installer and the manual install from my support page and both versions were Afterburn 4.1.3 and not 4.1.4.

Can I get an installer for 4.1.4? I am using Max 2014 x64. Thanks!

-Christian
  Reply
#4
Hello,

I have download the installer for 3ds max 2014 from our members area and it says it's the AferBurn 4.1.4 version.

Regards,
Kresimir Tkalcec
  Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)