10-17-2007, 07:14 AM
Hi guys,
Im trying to make snow being blown off the peak of a mountain.
I have a simple source just down one side of the mountain pointing up it with a directional velocity of 100 and a smoke amount of 200. I have a horizontal wind blowing across the mountain.
Some of my fume settings are as follows:
Quality 2
Max Iterations 100
Stride: .4
gravity .5
vorticity .05
Dissipation Strength: 0
Diffusion 0
The problem I have is that it starts off fine and looks good for a bit but then after about 250 frames the emitter hardly puts out any smoke, not enough to even get over the peak of the mountain.
I have tried increasing the source smoke amount but it doesnt really change anything.
Any ideas?
Im trying to make snow being blown off the peak of a mountain.
I have a simple source just down one side of the mountain pointing up it with a directional velocity of 100 and a smoke amount of 200. I have a horizontal wind blowing across the mountain.
Some of my fume settings are as follows:
Quality 2
Max Iterations 100
Stride: .4
gravity .5
vorticity .05
Dissipation Strength: 0
Diffusion 0
The problem I have is that it starts off fine and looks good for a bit but then after about 250 frames the emitter hardly puts out any smoke, not enough to even get over the peak of the mountain.
I have tried increasing the source smoke amount but it doesnt really change anything.
Any ideas?
Jordan Walsh
VFX Technical Director
Showreel 2012
Check out my scripts on ScriptSpot!
VFX Technical Director
Showreel 2012
Check out my scripts on ScriptSpot!